In this episode I show how to test a two wire magnetic crankshaft position sensor with a basic multimeter and jumper wires. If you're experiencing no start or stalling you might to test the sensor You can test the inductive type sensor with a multimeter through the steps below: Unplug the CKPS's electrical connector and set your DMM to low-range DC voltage settings. Stop your engine from starting, then turn the ignition key to its "On" position. Connect your DMM's black lead to the ground and connect the red lead to each sensor wire. You can easily test the crankshaft position (CKP) sensor, which is located near the crankshaft pulley, with a multimeter. No scan tool needed. In this tutorial, I'll show you how to do it. You'll easily and quickly find out if the CKP is good or bad on your 1991-1997 4.0L V6 Ford Explorer (Aerostar). Vay Tiền Nhanh Ggads.

how to test ckp sensor